Sysmgr-2 - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Error Message
directory. Aborting configuration snapshot.
Error Message
configuration directory (error-id [hex]). Aborting configuration snapshot.
Error Message SYSMGR-2-CFGSYNC_FAILURE: Syncing of the configuration to the standby
failed.
Error Message
OL-15956-01
SYSMGR-2-CFGSNAPSHOT_ABORTED: Configuration snapshot aborted.
An attempt to save a snapshot of the startup configuration has failed.
Explanation
Recommended Action Use the other syslog messages to verify that the problem has been corrected,
and then try again.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
SYSMGR-2-CFGSNAPSHOT_ABORTED_DIR: Unable to open the configuration
The destination location for the snapshot configuration could not be found.
Explanation
If the problem persists, use the init system CLI command from the
Recommended Action
switch(boot)# prompt to initialize the configuration partition. Note: This is a disruptive command.
This command will initialize the switch, reset the entire internal disk, and reformat the bootflash:
partition.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
SYSMGR-2-CFGSNAPSHOT_ABORTED_INIT: Unable to initialize the
Explanation An attempt to copy the startup configuration to the snapshot configuration has failed
because the old data could not be removed.
If the problem persists, issue the init system CLI command from the
Recommended Action
switch(boot)# prompt to initialize the configuration partition. Note: This is a disruptive command.
This command will initialize the switch, reset the entire internal disk, and reformat the bootflash:
partition.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Explanation A synchronization of the configuration to the standby has failed.
Use the other system messages to verify that the problem has been corrected,
Recommended Action
and try again.
Cisco MDS SAN-OS Release 2.1(1a).
Introduced
SYSMGR-2-CFGWRITE_ABORTED: Configuration copy aborted.
Explanation A configuration copy has failed.
Use the other syslog messages to verify that the problem has been corrected,
Recommended Action
and try again.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-363