Xbar_Client Messages - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual
Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
[chars] xbar access return_code [hex] ([chars]).
Error Message XBAR-5-XBAR_STATUS_REPORT: Module [dec] reported status for component
[dec] code [hex].
Error Message XBAR-5-XBAR_SW_INIT_FAIL: Xbar [[dec].[dec]] reported failure durinig
sw intialization return_code [hex] ([chars]).
Error Message
XBAR_CLIENT Messages
This section contains the crossbar client (XBAR_CLIENT) messages.
XBAR_CLIENT-2
Error Message
Cisco MDS 9000 Family System Messages Reference
2-462
XBAR-5-XBAR_SET_ACCESS_FAIL: Slot [dec] reported failure acquiring
The supervisor has experienced an xbar access failure.
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.0(1).
Introduced
An error status has been reported. If an error is on a supervisor module, the supervisor
Explanation
module is rebooted. In case of dual supervisors, a switchover occurs. If an error is on another
module, the module is power cycled.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Explanation
The supervisor has experienced an xbar setup failure.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.0(1).
Introduced
ZONE-6-ZS_INVALID_MEMBER: Invalid member [dec] [chars].
Invalid member type [dec] [chars] received from the API call.
Explanation
Recommended Action
Perform a manual build fabric using fcdomain's interface if you would like to
remove the unused virtual domain(s) from the fcdomain list.
Cisco MDS SAN-OS Release 3.0(1).
Introduced
XBAR_CLIENT-2-MEM_FULL: Memory allocation failed.
The crossbar client process has failed to allocate memory.
Explanation
Enter the show xbar-client event-history command or use a similar Fabric
Recommended Action
Manager/Device manager procedure to collect more information.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01
Advertisement
Table of Contents
