Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 366

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
SVC-4
Error Message
SS_EID_CA_EV_FIRST_DATA_PINNED ) Customer data pinned [chars].
Error Message
SS_EID_CA_EV_HWS_TO_SYNCHRONOUS ) Cache in write through mode due to pinned data
[chars].
Error Message
SS_EID_EC_ER_BATT_BELOW_CAPACITY ) Battery is below threshold capacity [chars].
Error Message
SS_EID_EC_ER_CANNOT_OPEN_IO_PROCESS_Q ) Internal error - IO process queue [chars].
Cisco MDS 9000 Family System Messages Reference
2-330
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
Explanation There is pinned customer data. This warning is given when data is pinned and there
were not already pinned data. Error log entries will exist for the underlying cause of the pinned data.
Perform problem determination on the error log to determine the cause of the
Recommended Action
pinned data and correct.
Introduced Cisco MDS SAN-OS Release 1.3(1).
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
Explanation The cache must operate in write through mode because of the amount of pinned data.
Perform problem determination on the error log to determine the cause of the
Recommended Action
pinned data and correct.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
Battery capacity is below threshold. The node will remain offline until the battery
Explanation
charge is sufficient to come up.
Wait for the battery to recharge. This may take many hours. If after several
Recommended Action
hours have passed and the node has not yet come up, follow these steps: 1. Reload the node. 2. If the
error persists, reinstall the code on the line card. The node(s) will then have to be removed and added
back to the cluster. 3. If the error persists, replace the Caching Services Module.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
The process was unable to open the needed message queue. The node was rebooted
Explanation
because of this error.
If this error is repeated continuously, follow these steps: 1. Reinstall the code
Recommended Action
on the node. The node will then have to be removed and added back to the cluster. 2. Ensure that the
software is at the latest level on the cluster. If not, upgrade the cluster and if necessary repeat Step
1 with the latest level of code. 3. If the error continues, ask your customer support representative for
assistance.
Introduced Cisco MDS SAN-OS Release 1.3(1).
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01