Ipsec-2 - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
IPsec-3
Error Message IPSEC-3-14_2_MODULE_PACKETS_DROPPED: [chars]: packets were dropped in
the module.
Error Message IPSEC-3-IPSEC_FIPS_TEST_FAILED: IPSEC FIPS compliance test failed.
Error Message IPSEC-3-IPSEC_MSG_SEND_FAILURE: failed to send [chars] to sap [dec]:
[chars].
IPsec-5
Error Message
Crypto map [chars] [dec]
Error Message
Cisco MDS 9000 Family System Messages Reference
2-158
Explanation The 14/2-port Multiprotocol Services (14/2-MPS) module dropped packets.
Enter the show ipsec internal crypto-acc interface gigabit <slot/port> CLI
Recommended Action
command or use a similar Fabric Manager/Device Manager procedure to collect drop statistics. If
you purchased Cisco support through a Cisco reseller, contact the reseller directly. If you purchased
support directly from Cisco Systems, contact Cisco Technical Support.
Cisco MDS SAN-OS Release 2.0(2b).
Introduced
Explanation IPsec FIPS compliance test failed.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.1(1).
Introduced
Failed to send a message.
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 2.0(1b).
Introduced
IPSEC-5-IPSEC_CMS_IF_ACL_UPDATED:
IP-ACL was updated while it is mapped to a crypto map that is bound to an interface(s).
Explanation
No action is required.
Recommended Action
Introduced Cisco MDS SAN-OS Release 2.0(1b).
IPSEC-5-IPSEC_DISABLED: IPSec Disabled.
IPsec is disabled.
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 2.0(1b).
Introduced
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
bound to interface(s).
IP ACL [chars] updated while
OL-15956-01