Span-5; Spi Messages - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
active sup was restarted stateless.
SPAN-6
Error Message
Error Message
[chars].
Error Message
switchover.

SPI Messages

This section contains the SPI messages.
Cisco MDS 9000 Family System Messages Reference
2-314
SPAN-5-STATELESS_RESTART_ON_ACTIVE: Span is restarting as Span on
Because of an unrecoverable error, the switched port analyzer (SPAN) on the active
Explanation
supervisor was restarted stateless. So, the standby SPAN restarts to get in sync with the stateless
SPAN on the active supervisor.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SPAN-6-SESSION_DOWN: Session [dec] is inactive ([chars]).
Session is inactive now. Traffic for this session is no longer spanned.
Explanation
Check the reason for session inactivity by entering the show span session CLI
Recommended Action
command or by using a similar Fabric Manager/Device Manager procedure.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
SPAN-6-SESSION_UP: Session [dec] is active, destination SD port
Session is active now. You can monitor spanned traffic at the destination SD port.
Explanation
Recommended Action No action is required.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
SPAN-6-STATELESS_SWITCHOVER: Span is starting stateless after
Explanation Active sessions are not preserved across switchover. The switched port analyzer
(SPAN) is starting stateless and the configuration will be reapplied to get back the active
configuration.
No action is required.
Recommended Action
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01