Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 177
Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message IPS-3-ISLB_ZONE_ACTIVATION_FAILED: iSLB zoneset activation returned
[hex] for VSAN [dec].
Error Message IPS-3-ISLB_ZONE_ACTIVATION_RETRY: iSLB zoneset activation returned
[hex] for VSAN [dec].
Error Message
[hex] for VSAN [dec].
IPS-4
Error Message IPS-4-FCIP_FTA_CFG_MISMATCH: [chars]: Mismatch in FCIP FICON Tape
Acceleration configuration with peer.
Error Message IPS-4-FCIP_FTA_VSAN_UPDATE_WARNING: FCIP FICON tape acceleration VSAN
update had an error ([chars]) on interface [chars] causing a flap of the interface.
OL-15956-01
iSLB zone set activation failed.
Explanation
If you purchased Cisco support through a Cisco reseller, contact the reseller
Recommended Action
directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support.
Introduced
Cisco MDS SAN-OS Release 3.0(1).
iSLB zone set activation failed because the zone server was busy.
Explanation
Retry the iSLB zone set activation.
Recommended Action
Cisco MDS SAN-OS Release 3.0(1).
Introduced
IPS-3-ISLB_ZONE_NO_ACTIVE_ZONESET: iSLB zonset activation returned
iSLB zone set activation failed because there is no active zone set.
Explanation
Recommended Action
Activate a zone set in the specified VSAN and retry.
Cisco MDS SAN-OS Release 3.0(1).
Introduced
Explanation
The FCIP FICON Tape Acceleration configuration does not match the peer's
configuration.
Adjust the FCIP FICON tape acceleration configuration to be consistent with
Recommended Action
the peer.
Introduced
Cisco MDS SAN-OS Release 3.0(1).
The FCIP FICON tape acceleration VSAN configuration experienced an error when
Explanation
disabling and enabling the VSAN over the FCIP tunnel. The FCIP tunnel was disabled and
re-enabled as a result of this error to ensure data integrity.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.0(1).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-141
Advertisement
Table of Contents
