Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 96

Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
Table of Contents

Advertisement

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
(Suspended due to incompatible mode).
Error Message
(Suspended due to incompatible speed).
Error Message
(Suspended due to incompatible remote switch WWN).
Error Message
down(TCP conn. closed - Keep alive expired).
Cisco MDS 9000 Family System Messages Reference
2-60
ETHPORT-5-IF_DOWN_SUSPENDED_BY_MODE: Interface [chars] is down
This interface belongs to a PortChannel and the operational mode of the interface is
Explanation
different from that of the PortChannel.
Recommended Action
Change the mode and the trunking mode of the PortChannel from auto and
check to ensure that the remote end of the interface also belongs to the same PortChannel.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
ETHPORT-5-IF_DOWN_SUSPENDED_BY_SPEED: Interface [chars] is down
This interface belongs to a PortChannel and operational mode of the interface is
Explanation
different from that of the PortChannel.
Change the speed of the PortChannel from auto and check to ensure that the
Recommended Action
remote end of the interface also belongs to the same PortChannel.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
ETHPORT-5-IF_DOWN_SUSPENDED_BY_WWN: Interface [chars] is down
This interface belongs to a PortChannel and the remote switch WWN of the interface
Explanation
is different from that of the PortChannel.
Ensure that this interface is connected to the same remote switch as all the
Recommended Action
other interfaces in the PortChannel.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
ETHPORT-5-IF_DOWN_TCP_KEEP_ALIVE_EXPIRED: Interface [chars] is
Explanation
The TCP session to the FCIP peer was closed due to loss of the TCP keepalive.
This may be due to loss of IP connectivity. Enter the show interface and show
Recommended Action
ip route CLI commands to provide the IP address of the peer and the route used to connect to this
FCIP peer. Enter traceroute [ipaddr] to check the connectivity to the peer. You can alternatively use
Fabric Manager and/or Device Manager instead of the command line method.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01

Advertisement

Table of Contents
loading

Table of Contents