Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 361

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
SS_EID_VL_ER_MDISK_RESOURCE_RAN_OUT ) Too many Managed Disks were presented to the
cluster [chars].
Error Message
SS_EID_VL_ER_QUORUM_DISK_CREATION_FAILURE ) A suitable Managed Disk for use as a
Quorum Disk was not found [chars].
Error Message
SS_EID_VL_ER_QUORUM_DISK_NOT_AVAILABLE ) Quorum Disk not available [chars].
OL-15956-01
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
Explanation The configuration is not valid. Too many devices have been presented to the cluster or
node.
1. Remove unwanted devices from the Fibre Channel network fabric. 2. Start
Recommended Action
a cluster discovery operation to find devices. 3. List all connected managed disks. Check that the
configuration is as expected. Mark the error you have just repaired fixed.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
No managed disk is suitable for use as a quorum disk. When a cluster is created, three
Explanation
disks are automatically selected as quorum disks. A quorum disk is needed to enable a tie-break
when some cluster members are missing. To become a quorum disk: The managed disk must be
accessible by all nodes in the cluster and the managed disk must have free extents. This error code
is produced when at least one quorum disk is not accessible by all nodes in the cluster. A quorum
disk might not be available because of a Fibre Channel network failure or because of a Fibre Channel
switch zoning problem.
1. Resolve any known Fibre Channel network problems. 2. Confirm that
Recommended Action
managed disks have been created and that those managed disks have free extents. 3. List the manage
disks. If at least one managed disk shows a mode of managed, mark the error you have just repaired
as fixed. 4. If you are unable to make the appropriate changes, ask your customer support
representative for assistance.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC-3-NODE_ERR_MSG: (SVC [dec]/[dec]
One or more quorum disks were not discovered by the node.
Explanation
1. Resolve any known Fibre Channel network problems. 2. Check managed
Recommended Action
disk status.If any managed disks are offline or excluded perform the disk controller problem
determination and repair procedures for the managed disks. 3. Start a cluster discovery operation. 4.
Check managed disk status. If all managed disks show a status of online, mark the error you have
just repaired as fixed.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-325