Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 403

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
successfully causing sup to reset.
Error Message
Error Message
not completed in specified time.
Error Message
supervisor failed to restore its snapshot (error-id [hex]).
Error Message
supervisor failed to store its snapshot (error-id [hex]).
OL-15956-01
SYSMGR-2-FORMAT_FAILURE_SUP_RESET: Failure to format a partition
The partition used to store nonvolatile persistent storage service (PSS) files could not
Explanation
be formatted successfully. The supervisor will be reset.
Recommended Action If the problem persists, contact customer support. If you purchased Cisco
support through a Cisco reseller, contact the reseller directly. If you purchased support directly from
Cisco Systems, contact Cisco Technical Support.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SYSMGR-2-GSYNC_ABORT: Global sync aborted by signal.
The initial synchronization of the services was terminated. The synchronization will be
Explanation
attempted again later.
Enter the reload module CLI command or use an equivalent Fabric
Recommended Action
Manager/Device Manager procedure to reset the standby supervisor.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
SYSMGR-2-GSYNC_GET_TIMEOUT:
Service failed to complete global sync in specified time. The standby will no longer act
Explanation
as a high availability standby.
Recommended Action If the problem persists, contact customer support. If you purchased Cisco
support through a Cisco reseller, contact the reseller directly. If you purchased support directly from
Cisco Systems, contact Cisco Technical Support.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SYSMGR-2-GSYNC_READY_SRVFAILED: Service "[chars]" on standby
Explanation The initial synchronization of service failed.
If you purchased Cisco support through a Cisco reseller, contact the reseller
Recommended Action
directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SYSMGR-2-GSYNC_SNAPSHOT_SRVFAILED: Service "[chars]" on active
The initial synchronization of service failed.
Explanation
If you purchased Cisco support through a Cisco reseller, contact the reseller
Recommended Action
directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Request for global sync for UUID [hex]
Cisco MDS 9000 Family System Messages Reference
2-367