Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 368
Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Internal error - fork failed [chars].
Error Message
SS_EID_EC_ER_INTERNAL_EXIT_LOGIC_ERR ) Internal error - bad exit code [chars].
Error Message
SS_EID_EC_ER_INTERNAL_UNKNOWN_EXEC_MODE ) Internal error - run mode [chars].
Error Message
SS_EID_EC_ER_IOP_EXITED_DUE_TO_SIGNAL ) Internal error - signal caused exit
[chars].
Cisco MDS 9000 Family System Messages Reference
2-332
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec] SS_EID_EC_ER_FORK_FAILED )
The process cannot launch the I/O program. Node was rebooted because of this error.
Explanation
If this error is repeated continuously, follow these steps: 1. Reinstall the code
Recommended Action
on the node. The node will then have to be removed and added back to the cluster. 2. Ensure that the
software is at the latest level on the cluster. If not, upgrade the cluster and if necessary repeat step 1
with the latest level of code. 3. Ask your customer support representative for assistance, if the error
continues.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
Node was warmstarted because of an internal logic error.
Explanation
1. Ensure that the software is at the latest level on the cluster. 2. Ask your
Recommended Action
customer support representative for assistance.
Introduced
Cisco MDS SAN-OS Release 1.3(1).
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
Node was rebooted because of an internal logic error.
Explanation
1. Ensure that the software is at the latest level on the cluster. 2. Ask your
Recommended Action
customer support representative for assistance.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
The I/O process exited because of a signal that was not caught. Node was warm started
Explanation
because of this error.
1. Ensure that the software is at the latest level on the cluster.2. Ask your
Recommended Action
customer support representative for assistance.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01
Advertisement
Table of Contents
