Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 280

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message PORT-5-IF_DOWN_LOOPBACK_DIAG_FAILURE: Interface [chars] is down (Diag
failure).
Error Message PORT-5-IF_DOWN_LOOPBACK_ISOLATION: Interface [chars] is down
(Isolation due to port loopback to same switch).
Error Message PORT-5-IF_DOWN_MODULE_REMOVED: Interface [chars] is down (module
removed).
Error Message PORT-5-IF_DOWN_NON_PARTICIPATING: Interface [chars] is down (Non
participating).
Error Message PORT-5-IF_DOWN_NONE: Interface [chars] is down (None).
Cisco MDS 9000 Family System Messages Reference
2-244
Introduced Cisco MDS SAN-OS Release 3.0(1).
Diagnostics failed on the interface.
Explanation
Enter the attach module command or use a similar Fabric Manager procedure
Recommended Action
to connect to the module to collect more information about the failed interface.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Explanation The interface is looped back to another interface on the same switch.
Check the connectivity of this interface and ensure that it is connected to
Recommended Action
another switch.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Interface is down because the module was removed.
Explanation
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
The loop interface has been put into nonparticipating mode.
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Explanation There is no apparent reason the interface is down.
Enter the show port internal all interface command or use a similar Fabric
Recommended Action
Manager procedure to determine why the interface went down.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01