Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 215

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message IVR-3-UNLOCK_FAILED: [chars].
Error Message IVR-3-VSAN_SEGMENTED: [chars].
Error Message IVR-3-ZS_POLICY_IS_DENY_NO_ACTIVE_ZS: Default zone behavior policy
changed to deny on VSAN [dec] and there is no active zoneset.
Error Message
changed to permit on VSAN [dec] and the force option is off.
Error Message
policy changed to permit on VSAN [dec] and regular zoneset deactivated.
OL-15956-01
An error occurred while releasing the lock. The reason for the failure is shown in the
Explanation
error message.
If you purchased Cisco support through a Cisco reseller, contact the reseller
Recommended Action
directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support.
Cisco MDS SAN-OS Release 2.0(1b).
Introduced
Explanation VSAN is segmented. VSAN is removed from the topology graph and therefore
inter-VSAN traffic cannot flow through this VSAN.
Recommended Action To correct the segmentation, use one of the following methods:
Modify one of the VSAN IDs so it is no longer a segmented VSAN.
–
Add a different AFID to one of the VSANs so the AFID/VSAN combination is unique.
–
Bring up a link in the segmented VSAN that goes between the two segments so that they are no
–
longer segmented.
Cisco MDS SAN-OS Release 2.1(1a).
Introduced
The default zone behavior is changed to deny, and there is no active zone set.
Explanation
Inter-VSAN zone members may not be able to communicate in this VSAN.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
IVR-3-ZS_POLICY_IS_PERMIT_NO_FORCE: Default zone behavior policy
The default zone behavior is changed to permit and the force option is off. Inter-VSAN
Explanation
zone set activation in this VSAN has failed.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
IVR-3-ZS_POLICY_IS_PERMIT_ZS_DEACTIVATED: Default zone behavior
Default zone behavior is changed to permit and the regular zone set is deactivated.
Explanation
Inter-VSAN zone members may not be able to communicate.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.3(4b).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-179