Fspf-2 - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
FSPF-3
Error Message
[dec] : [chars].
Error Message
VSAN [dec].
Error Message
[chars] VSAN [dec], Error = [chars].
Error Message
Error = [chars].
OL-15956-01
FSPF-3-BAD_FC2_PKT: Received bad FC2 packet on interface [chars] VSAN
Explanation Fabric Shortest Path First (FSPF) received a bad FC2 packet on the interface and VSAN
shown in the error message. The error description is shown in the error message.
FSPF daemon has received a bad FC frame. Provide the output of the debug
Recommended Action
fc2 pkt CLI command to your customer service representative.You can alternatively use Fabric
Manager and/or Device Manager instead of the command line method.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
FSPF-3-CHECKSUM_FAIL: Checksum test failed for LSR domain [dec] in
Periodic database checksum test failed for LSR for the domain and VSAN shown in the
Explanation
error message.
This indicates that the internal database is corrupted because of some memory
Recommended Action
corruption problem. Provide the output of show fspf database to your customer service
representative. You may need to power cycle the switch.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
FSPF-3-FC2_PROC_ERR: Error in processing [chars] packet on interface
An error occurred in processing the FC2 packet on the interface and VSAN shown in
Explanation
the error message. The internal error code is also shown in the error message.
Enter debug fspf error to get more information. Make sure there is no
Recommended Action
misconfiguration of FSPF parameters on the two ends of the interface. Provide the output of the
show fspf vsan [vsan-id] and show fspf vsan[vsan-id] interface commands and the debug fspf fc
pkt command results for the specific interface to your customer service representative.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
FSPF-3-FLOOD_ERR: Error in flooding the local LSR in VSAN [dec] ,
Fabric Shortest Path First (FSPF) had an error in flooding the local LSR in VSAN shown
Explanation
in the error message. The error description is shown in the error message.
Recommended Action Provide the output of the debug fspf flood and debug fspf error CLI
commands. If an error is reported in transmitting a packet, check if the interface is up and then enter
the debug fc2 error CLI command.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-115