Svc-5; Svc-6 - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
SS_EID_CA_EV_HWS_TO_ASYNCHRONOUS ) Pinned data reduced; cache can operate normally
[chars].
Error Message
recharged [chars].
Error Message
Poweroff or power failure detected [chars].
Error Message
withdrawn [chars].
Error Message
Flash Copy Copied [chars].
Cisco MDS 9000 Family System Messages Reference
2-342
SVC-6-NODE_INFO_MSG: (SVC [dec]/[dec]
Explanation Enough customer data has been unpinned that the cache is no longer required to operate
in write through mode because of the pinned data. Note that the cache may still operate in write
through mode for other reasons.
No action is required.
Recommended Action
Introduced Cisco MDS SAN-OS Release 1.3(1).
SVC-6-NODE_INFO_MSG: (SVC [dec]/[dec] SS_EID_EC_ER_BATT_OK ) Battery
Battery capacity has been restored to above the threshold value. The node will now
Explanation
come online.
Recommended Action No action is required.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC-6-NODE_INFO_MSG: (SVC [dec]/[dec] SS_EID_EC_ER_BATT_POWER_DOWN )
Explanation The process has received a poweroff or power failure indication. The node is shutting
down.
Restore power. If power was not removed and this occurs, follow these steps:
Recommended Action
1. Reload the node. 2. Reinstall the code on the line card, if the error persists. The node(s) then has
to be removed and added back to the cluster. 3. Replace the Caching Services Module, if the error
persists.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC-6-NODE_INFO_MSG: (SVC [dec]/[dec] SS_EID_EC_ER_PWR_BUTTON ) Power
Explanation Node software was notified that AC power was being shut off, or the Caching Services
Module was being reset.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC-6-NODE_INFO_MSG: (SVC [dec]/[dec] SS_EID_FC_ER_COPY_COMPLETED )
The flash copy mapping or consistency group has entered the "idle_copied" state.The
Explanation
target disk now contains a complete copy and is no longer dependent on the source.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01