Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 211

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
FCID [chars] may not be able to participate in Inter-VSAN zone since domain [dec]
is disallowed in the interop mode for VSAN [dec].
Error Message IVR-3-DOMAIN_UNAVAILABLE: Device with port WWN [chars] and FCID
[chars] may not be able to participate in Inter-VSAN zone since domain [dec] is
already assigned in VSAN [dec].
Error Message IVR-3-FC2_ERROR: FC2 API [chars] failed with error [hex] for [chars].
Error Message IVR-3-INTERNAL_ERROR: Internal error: [chars].
Error Message IVR-3-FCID_REWRITE_REQUEST_TO_ACL_FAILED: fcid rewrite [chars]
request vsan [dec] did [chars] sid [chars] failed:[chars].
OL-15956-01
IVR-3-DOMAIN_DISALLOWED_IN_INTEROP: Device with port WWN [chars] and
Explanation VSAN interop modes place restrictions on what domain ranges are allowed. This
domain is out of the range allowed for this interop mode. Refer to the Cisco MDS 9000 Family CLI
Configuration Guide or Cisco MDS 9000 Family Fabric Manager Configuration Guide for details
on the domain range limitations.
Change the domain of the switch to which this IVR zone member is connected
Recommended Action
so that it is within the allowed domain list for the interop mode. The domain identifier can be
statically assigned using fcdomain interface. You can also configure a range of domains allowed in
a VSAN using the fcdomain allowed-domains' interface.'
Cisco MDS SAN-OS Release 3.0(1).
Introduced
Device with the named port WWN and FC ID may not be able to participate in
Explanation
Inter-VSAN zone because the named domain is already assigned in the named VSAN.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 3.0(1).
IVR invoked a Fibre Channel Layer 2 (FC-2) API for a socket and received an error
Explanation
code. The error message describes the API and the error.
No action is required.
Recommended Action
Introduced Cisco MDS SAN-OS Release 1.3(1).
The IVR process encountered a general error, one that does not fall in any of the
Explanation
categories. The error message describes the error and its context.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
This happens either after IVR retried the request few times or ACL experienced error
Explanation
while processing the request.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.0(1).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-175