Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 370

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
SS_EID_EC_ER_UNKNOWN_MESSAGE_TYPE ) Internal error - message type [chars].
Error Message
) Internal error - waitpid failed [chars].
Error Message
Error Message
SS_EID_FC_ER_MAPPING_STOPPED ) FlashCopy has been stopped [chars].
Cisco MDS 9000 Family System Messages Reference
2-334
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
Node was rebooted because of an internal logic error.
Explanation
1. Ensure that the software is at the latest level on the cluster. 2. Ask your
Recommended Action
customer support representative for assistance.
Introduced Cisco MDS SAN-OS Release 1.3(1).
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec] SS_EID_EC_ER_WAITPID_FAILED
The process cannot launch the I/O program properly. Node was warm started because
Explanation
of this error.
If this error is repeated continuously, follow these steps: 1. Reinstall the code
Recommended Action
on the node. The node will then have to be removed and added back to the cluster. 2. Ensure that the
software is at the latest level on the cluster. If not, upgrade the cluster and if necessary repeat step 1
with the latest level of code. 3. Ask your customer support representative for assistance, if the error
continues.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
The process cannot warm start the memory device. Node was rebooted because of this
Explanation
error.
If this error is repeated continuously, follow these steps: 1. Reinstall the code
Recommended Action
on the node. The node will then have to be removed and added back to the cluster. 2. Ensure that the
software is at the latest level on the cluster. If not, upgrade the cluster and if necessary repeat step 1
with the latest level of code. 3. Ask your customer support representative for assistance, if the error
continues.
Introduced Cisco MDS SAN-OS Release 1.3(1).
SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec]
A flash copy mapping task stopped because of an error. A stopped flash copy may affect
Explanation
the status of other vdisks in the same I/O group. Preparing the stopped flash copies as soon as
possible is advised.
1. Correct higher priority errors and then start the flash copy task again. 2.
Recommended Action
Mark the error you have just repaired as fixed.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01