Bootvar-2 - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
Error Message
compatible with the current platform in Sup [dec].
BOOTVAR-3
Error Message
failed, error=[hex].
Error Message BOOTVAR-3-AUTOCOPY_FAILED_STANDBY_FULL: Autocopy of file [chars] to
standby failed due to not enough disk space on standby.
Error Message BOOTVAR-3-INIT_FAILED: Initialization failed: Component [chars].
Cisco MDS 9000 Family System Messages Reference
2-16
BOOTVAR-2-CONFIG_ERROR: Failed to update boot configuration.
An error has occurred during the update of the boot configuration files.
Explanation
Recommended Action Ensure that there is enough space on the flash. Enter the show boot CLI
command to check the configured image names, and enter show loader internal configuration to
compare them with the current bootloader configuration. If they are not coherent, enter the write
erase CLI command and try to save the configuration again. You can alternatively use Fabric
Manager and/or Device Manager instead of the command line method.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
BOOTVAR-2-IMAGE_NOT_COMPATIBLE: Warning: image [chars] is not
The input image name is not compatible with the current platform.
Explanation
Make sure a correct image is specified before rebooting the system.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
BOOTVAR-3-AUTOCOPY_FAILED: Autocopy of file [chars] to standby
The automatic copy feature failed to copy the image shown to the standby module.
Explanation
Check the error ID for the specified reason.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
There is not enough disk space on the standby supervisor for the file to be copied.
Explanation
Clear space on the standby supervisor.
Recommended Action
Cisco MDS SAN-OS Release 3.0(1).
Introduced
The service failed to start. The failure occurred during initialization of the component
Explanation
shown in the error message.
Explanation Enter the show process CLI command to check the status of the other processes. Check
the component shown in the error message. You can alternatively use Fabric Manager and Device
Manager instead of the command line interface.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01