Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 95
Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
software failure).
Error Message
down(Tunnel source module not online).
Error Message
(Tunnel port src interface unbound).
Error Message
src port removed).
Error Message
OL-15956-01
ETHPORT-5-IF_DOWN_SOFTWARE_FAILURE: Interface [chars] is down (Port
The software servicing the data path on the port has failed.
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
ETHPORT-5-IF_DOWN_SRC_MOD_NOT_ONLINE: Interface [chars] is
The module that has the tunnel source port of this FCIP interface is not fully online.
Explanation
Recommended Action
The module that has the tunnel source port is coming online. Enter show
module to find the module status.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
ETHPORT-5-IF_DOWN_SRC_PORT_NOT_BOUND: Interface [chars] is down
The tunnel port source interface is unbound.
Explanation
Recommended Action
No action is required.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
ETHPORT-5-IF_DOWN_SRC_PORT_REMOVED: Interface [chars] is down(Tunnel
Explanation
The tunnel source port of this FCIP interface has been removed.
The source interface with an IP address that matches the IP address of the
Recommended Action
bound entity is removed. This happens normally when the module on which the source interface
exists is removed.
Introduced
Cisco MDS SAN-OS Release 1.2(2a).
ETHPORT-5-IF_DOWN_SUSPENDED: Interface [chars] is down (Suspended).
This interface belongs to a PortChannel and has been suspended because of an error
Explanation
during port bringup.
Enter the shutdown CLI command then no shutdown. If this happens again,
Recommended Action
enter the show port internal info and show port internal event-history CLI commands on the
interface to collect more information. You can alternatively use Fabric Manager and/or Device
Manager instead of the command line method.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-59
Advertisement
Table of Contents
