Juniper JUNOS OS 10.3 - SOFTWARE Manual page 1302

Complete Software Guide for Junos
Related
Documentation
lacp
Syntax
Hierarchy Level
Release Information
Description
Default
Options
Required Privilege
Level
Related
Documentation
1206
®
OS for EX Series Ethernet Switches, Release 10.3
Configuring Gigabit Ethernet Interfaces (CLI Procedure) on page 1153
Configuring Aggregated Ethernet Interfaces (CLI Procedure) on page 1157
Configuring a Layer 3 Subinterface (CLI Procedure) on page 1165
Configuring Routed VLAN Interfaces (CLI Procedure) on page 1379
Configuring the Virtual Management Ethernet Interface for Global Management of a
Virtual Chassis (CLI Procedure) on page 1027
EX Series Switches Interfaces Overview on page 1095
Junos OS Network Interfaces Configuration Guide at
http://www.juniper.net/techpubs/software/junos/index.html
lacp mode {
periodic interval;
}
[edit interfaces aex aggregated-ether-options]
Statement introduced in Junos OS Release 9.0 for EX Series switches.
Configure the Link Aggregation Control Protocol (LACP).
LACP is not enabled.
—LACP mode:
mode
—Initiate transmission of LACP packets
active
—Respond to LACP packets
passive
The remaining statement is explained separately.
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Example: Configuring Aggregated Ethernet High-Speed Uplinks with LACP Between
a Virtual Chassis Access Switch and a Virtual Chassis Distribution Switch on page 977
Configuring Aggregated Ethernet LACP (CLI Procedure) on page 1161
Configuring Aggregated Ethernet Interfaces (J-Web Procedure) on page 1158
Understanding Aggregated Ethernet Interfaces and LACP on page 1099
Junos OS Network Interfaces Configuration Guide at
http://www.juniper.net/techpubs/software/junos/index.html
Copyright © 2010, Juniper Networks, Inc.