Configuring Aggregated Ethernet Lacp (Cli Procedure); Table 171: Vlan Options; Table 172: Ip Options - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Complete Software Guide for Junos

Table 171: VLAN Options

Field
Port Mode

Table 172: IP Options

Field
IPv4 Address
IPv6 Address
Related
Documentation
1160
®
OS for EX Series Ethernet Switches, Release 10.3
Function
Specifies the mode of operation for the
port: trunk or access.
Function
Specifies an IPv4 address for the selected
LAG.
Specifies an IPv6 address for the selected
LAG.
Configuring Aggregated Ethernet Interfaces (CLI Procedure) on page 1157
Example: Configuring Aggregated Ethernet High-Speed Uplinks Between a Virtual
Chassis Access Switch and a Virtual Chassis Distribution Switch on page 970
Example: Configuring Aggregated Ethernet High-Speed Uplinks with LACP Between
a Virtual Chassis Access Switch and a Virtual Chassis Distribution Switch on page 977
Verifying the Status of a LAG Interface on page 1168
Configuring Aggregated Ethernet LACP (CLI Procedure) on page 1161
Your Action
If you select , you can:
Trunk
1. Click to add a VLAN member.
Add
2. Select the VLAN and click
3. (Optional) Associate a native VLAN
ID with the port.
If you select Access , you can:
1. Select the VLAN member to be
associated with the port.
2. (Optional) Associate a VoIP VLAN
with the interface. Only a VLAN with
a VLAN ID can be associated as a
VoIP VLAN.
Click .
OK
Your Action
1. Select the check box IPv4 address
2. Type an IP address—for example,
10.10.10.10 .
3. Enter the subnet mask or address
prefix. For example, 24 bits
represents 255.255.255.0
4. Click .
OK
1. Select the check box IPv6 address
2. Type an IP address—for example,
2001:ab8:85a3::8a2e:370:7334
3. Enter the subnet mask or address
prefix.
4. Click .
OK
Copyright © 2010, Juniper Networks, Inc.
OK .
.
.
.
.