Juniper JUNOS OS 10.3 - SOFTWARE Manual page 1138

Complete Software Guide for Junos
Meaning
Related
Documentation
Replacing a Member Switch of a Virtual Chassis Configuration (CLI Procedure)
1042
®
OS for EX Series Ethernet Switches, Release 10.3
To view the path a packet takes when going from a source interface to a destination
interface in a Virtual Chassis configuration using the CLI, enter the following command:
show virtual-chassis vc-path
In the J-Web interface the top half of the screen displays details of the Virtual Chassis
configuration, such as:
Member
Role
Interface
Type
Speed
Neighboring Member ID
Link Status
Error count
Click the Stop button to stop fetching values from the switch, and click the
to start plotting data again from the point where it was stopped.
To view a graph of the statistics for the selected Virtual Chassis port of the member, click
Show Graph .
—Displays the time interval you have set for page refresh.
Refresh Interval (sec)
Click Clear Statistics to clear the monitoring statistics for the selected member switch.
You can specify the interval at which the member details and statistics must be refreshed.
The bottom half of the screen displays a chart of the Virtual Chassis statistics, and the
port packet counters.
For details about the output from CLI commands, see show virtual-chassis status and
show virtual-chassis vc-port statistics.
Configuring a Virtual Chassis (CLI Procedure) on page 1011
Configuring a Virtual Chassis (J-Web Procedure) on page 1015
Example: Configuring a Virtual Chassis with a Master and Backup in a Single Wiring
Closet on page 947
Verifying the Member ID, Role, and Neighbor Member Connections of a Virtual Chassis
Member on page 1038
You can replace a member switch of a Virtual Chassis configuration without disrupting
network service for the other members. You can retain the existing configuration of the
Start
Copyright © 2010, Juniper Networks, Inc.
button