Configuring Vlan Options And Port Mode - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Table 169: Recommended CoS Settings for Port Roles (continued)
CoS Parameter
assured-scheduler
best-effort-scheduler
Classifiers
Related
Documentation
Configuring Gigabit Ethernet Interfaces (CLI Procedure)

Configuring VLAN Options and Port Mode

Copyright © 2010, Juniper Networks, Inc.
CLI Command
The CLI commands are:
set class-of-service schedulers assured-scheduler transmit-rate percent 25
set class-of-service schedulers strict-priority-scheduler buffer-size percent
25
set class-of-service schedulers strict-priority-scheduler priority low
The CLI commands are:
set class-of-service schedulers best-effort-scheduler transmit-rate percent
35
set class-of-service schedulers best-effort-scheduler buffer-size percent 40
set class-of-service schedulers best-effort-scheduler priority low
The classifiers are:
set class-of-service classifiers ieee-802.1 juniper_ieee_classifier import
default forwarding-class voice loss-priority low code-points 101
set class-of-service classifiers dscp juniper_dscp_classifier import default
forwarding-class voice loss-priority low code-points 101110
Configuring Gigabit Ethernet Interfaces (J-Web Procedure) on page 1143
Configuring Gigabit Ethernet Interfaces (CLI Procedure) on page 1153
An Ethernet interface must be configured for optimal performance in a high-traffic
network. EX Series switches include a factory default configuration that:
Enables all the network interfaces on the switch
Sets a default port mode (access)
Sets default link settings
Specifies a logical unit (
EX8200 switches)
Specifies Rapid Spanning Tree Protocol (RSTP) and Link Layer Discovery Protocol
(LLDP)
This topic describes:
Configuring VLAN Options and Port Mode on page 1153
Configuring the Link Settings on page 1154
Configuring the IP Options on page 1155
The factory default configuration includes a default VLAN and enables interfaces for the
access port mode. Access interfaces typically connect to network devices such as PCs,
printers, IP telephones, and IP cameras.
unit 0 ) and assigns it to family ethernet-switching
Chapter 52: Configuring Interfaces
(except on
1153