Juniper JUNOS OS 10.3 - SOFTWARE Manual page 1123

Related
Documentation
Configuring the Virtual Management Ethernet Interface for Global Management of a
Virtual Chassis (CLI Procedure)
Copyright © 2010, Juniper Networks, Inc.
Press . You will see
9. Enter
Once the configuration has been accepted, press
10.
menu.
You can also use the LCD panel to delete a VCP, thus resetting the port to an uplink
module port or an EX4200-24F network port.
To reset to an uplink module port using the LCD panel:
vcp-0/1/2
Press Menu until you see
1.
Press until you see
2. Menu
Press Enter . You will see
3.
Press . You will see
4. Menu
Press . You will see
Enter
5.
Press . You will see
6. Enter
Press until you see
Menu
7.
Press . You will see
8. Enter
Press until you see
Menu
9.
Press . You will see
10. Enter
Once the configuration has been accepted, press
11.
menu.
LCD Panel in EX3200 and EX4200 Switches
Configuring a Virtual Chassis (CLI Procedure) on page 1011
Configuring a Virtual Chassis (J-Web Procedure) on page 1015
Setting an Uplink Module Port as a Virtual Chassis Port (CLI Procedure) on page 1023
Understanding Interface Naming Conventions on EX Series Switches on page 1097
If you want to configure and manage a Virtual Chassis remotely through SSH or Telnet,
configure the virtual management Ethernet (VME) interface on the master of the Virtual
Chassis. You can configure and manage all members of the Virtual Chassis through this
single global interface.
Power on the switch that you want to function as the master.
1.
Check the front-panel LCD to confirm that the switch has powered on correctly.
2.
Run the EZ Setup program on the switch, specifying the identification parameters.
3.
See "Connecting and Configuring an EX Series Switch (CLI Procedure)" on page 187
.
CONFIGURING ...
Enter
MAINTENANCE MENU .
.
REQUEST VC PORT
SET VC PORT? .
.
DELETE VC PORT?
.
DELETE FPC 0?
.
DELETE PIC 0?
.
DELETE PIC 1?
.
DELETE PORT 0?
.
DELETE PORT 2?
.
CONFIGURING ...
Enter
Chapter 45: Configuring Virtual Chassis
to return to the
MAINTENANCE
to return to the
MAINTENANCE
1027