Configuring The Ip Options - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Configuring the IP Options

Copyright © 2010, Juniper Networks, Inc.
To configure the link settings:
Set link settings for a Gigabit Ethernet interface:
[edit]
user@switch# set interfaces ge-fpc/pic/port ether-options
Set link settings for a 10-Gigabit Ethernet interface:
[edit]
user@switch# set interfaces xe-fpc/1/port ether-options
NOTE: An uplink port in an EX2200, EX3200, and EX4200 switch always has
a PIC value of
1.
is on the left-hand uplink module and a PIC value of
uplink module.
For an EX2200, EX3200, or EX4500 switch or an EX4200 standalone switch,
fpc refers to the switch itself and is always
fpc refers to the member ID. In an EX8200 switch, fpc refers to the line card
number.
The ether-options statement allows you to modify the configuration:
—Specify an aggregated Ethernet bundle. See "Configuring Aggregated Ethernet
802.3ad
Interfaces (CLI Procedure)" on page 1157.
—Enable or disable autonegotation of flow control, link mode, and
auto-negotiation
speed.
—Enable or disable flow control.
flow-control
—Specify
link-mode full-duplex
—Specify ,
speed 10m 100m
To specify an IP address for the logical unit using IPv4:
[edit]
user@switch# set interfaces interface-name unit logical-unit-number family inet address
ip-address
To specify an IP address for the logical unit using IPv6:
[edit]
user@switch# set interfaces interface-name unit logical-unit-number family inet6 address
ip-address
An uplink port in an EX4500 switch has a PIC value of
0
, , or
half-duplex automatic
, , or .
1g autonegotiation
Chapter 52: Configuring Interfaces
if it is on the right-hand
2
. In a Virtual Chassis configuration,
.
if it
1
1155