Juniper JUNOS OS 10.3 - SOFTWARE Manual page 1346

Complete Software Guide for Junos
Table 180: show interfaces ge- Output Fields (continued)
Field Name Field Description
Information about link autonegotiation:
Autonegotiation
information
Negotiation status:
Incomplete
No autonegotiation
configured or does not perform autonegotiation.
Complete
autonegotiation and the autonegotiation process is successful.
Link partner status
that performs autonegotiation and the autonegotiation process is successful.
Link partner:
Link mode
either
Flow control
device. For Gigabit Ethernet interfaces, types are
supports
supports
supports
Remote fault
indicates a receive link error.
Negotiation error
link partner is going offline.
Link partner speed
Local resolution
Flow control
device. For Gigabit Ethernet interfaces, types are
supports
supports
supports
Remote fault
receive),
detected on receive).
Packet Information about the configuration of the Packet Forwarding Engine:
Forwarding
Destination slot
Engine
configuration
NOTE: For an EX2200, EX3200, or EX4500 switch or an EX4200 standalone
switch, the FPC slot number refers to the switch itself and is always
Chassis configuration, the FPC slot number refers to the member ID. In an
EX8200 switch, the FPC slot number refers to the line card slot number.
Logical Interface
Name of the logical interface.
Logical interface
Index number of the logical interface, which reflects its initialization sequence.
Index
SNMP interface index number for the logical interface.
SNMP ifIndex
Unique number for use by Juniper Networks technical support only.
Generation
1250
®
OS for EX Series Ethernet Switches, Release 10.3
—Ethernet interface has the speed or link mode configured.
—Remote Ethernet interface has the speed or link mode
—Ethernet interface is connected to a device that performs
— OK when Ethernet interface is connected to a device
—Depending on the capability of the attached Ethernet device,
or .
Full-duplex Half-duplex
—Types of flow control supported by the remote Ethernet
on receive and transmit),
PAUSE
on transmit), and
PAUSE Symmetric/Asymmetric
on both receive and transmit or
PAUSE
—Remote fault information from the link partner—
indicates that the link partner is receiving.
OK
indicates a negotiation error.
—Speed of the link partner.
—Information from the link partner:
—Types of flow control supported by the remote Ethernet
on receive and transmit),
PAUSE
PAUSE on transmit), and Symmetric/Asymmetric
PAUSE on both receive and transmit or
—Remote fault information.
Offline (local interface is offline), and
—FPC slot number.
(link partner
Symmetric
(link partner
Asymmetric
(link partner
only on receive).
PAUSE
Failure
Offline indicates that the
(link partner
Symmetric
(link partner
Asymmetric
(link partner
PAUSE only on receive).
Link OK (no error detected on
Link Failure (link error
. In a Virtual
0
Copyright © 2010, Juniper Networks, Inc.
Level of Output
extensive
extensive
All levels
none
detail extensive
none
detail extensive
detail extensive