Fcrconfigure - Brocade Communications Systems 8 Command Reference Manual

2

fcrConfigure

fcrConfigure
Sets FC Router configuration parameters.
Synopsis fcrconfigure
Description Use this command to configure the FC Router parameters for this platform. This is an interactive
command.
This command cannot execute on a system with the FC Router feature enabled. First disable FC
routing by using fosConfig or disable the switch with switchDisable.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command interactively prompts for the following parameter:
Backbone Fabric ID A fabric ID uniquely identifies a fabric in FC Router configurations. The
Examples To configure FC Router parameters:
See Also fosConfig, switchDisable, switchEnable, switchShow
280
backbone fabric is the fabric attached to the U_Ports—for example,
E/F_Ports—of this switch. The backbone fabric ID must be unique across all
FC Router-connected fabrics. The current Backbone Fabric ID can be
displayed using the switchShow command.
fcr:admin> fcrconfigure
FC Router parameter set. <cr> to skip a parameter
Please make sure new Backbone Fabric ID does not conflict with any configured
EX-Port's Fabric ID
Backbone fabric ID: (1-128)[128]
Fabric OS Command Reference
53-1001764-02