Fcrconfigure - Brocade Communications Systems Brocade 8/12c Command Reference Manual

fcrConfigure

Sets FC Router configuration parameters.
SYNOPSIS
fcrconfigure
DESCRIPTION
Use this command to configure FC Router parameters. This is an interactive command.
Before you can execute this command, you must disable FC routing by using the fosConfig command
and disable the switch with the switchDisable command.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command interactively prompts for the following parameter:
Backbone Fabric ID
EXAMPLES
To configure FC Router parameters:
SEE ALSO
fosConfig, switchDisable, switchEnable,
Fabric OS Command Reference
53-1001764-01
A fabric ID uniquely identifies a fabric in FC Router configurations. The backbone
fabric is the fabric attached to the U_Ports of the switch, for example, E_Ports or
F_Ports. The backbone fabric ID must be unique across all fabrics connected to
the FC Router. Use the switchShow command to display the current Backbone
Fabric ID.
fcr:admin> fcrconfigure
FC Router parameter set. <cr> to skip a parameter
Please make sure new Backbone Fabric ID does \
not conflict with any configured EX-Port's Fabric ID
Backbone fabric ID: (1-128)[128]
switchShow
22
fcrConfigure
301