Omron SYSMAC CS1D-PD Series Operation Manual page 640

Precautions in Replacing CS1-H PLCs with CS1D PLCs
Item
Pro- CX-Programmer
gram- restrictions
ming
Devices
Device type setting CX-Programmer Version 3.@
Connecting to PLC The Programming Device
600
Duplex CPU Systems
Supported from CX-Program-
mer version 3.1.
Supported from CX-Program-
mer version 2.1 or lower with
the following restrictions.
Version 2.1: Duplex error dis-
plays, PLC Setup settings,
and online Unit replacement
are not supported.
Version 3.0: Online Unit
replacement are not sup-
ported.
Supported from CX-Program-
mer Ver. 9.7.
or Lower
Select "CS1H-H" as the
device type. When using
duplex functions, select
Duplex Settings from the
Option Menu in the PLC
Setup. Duplex operation must
be set in the PLC Setup.
CX-Programmer Version 4.0
or Higher
Select "CS1D-H" as the
device type when using a
Duplex CPU System. The
"CS1H-H" can also be
selected as the device type,
but if it is, then Duplex Set-
tings must be selected from
the Option Menu in the PLC
Setup. Duplex operation must
be set in the PLC Setup.
CS1D-CPU@@HA does not
support an online connection
even if "CS1H-H" is selected.
must be connected to the
active CPU Unit; it will not be
possible to transfer data or
otherwise write data when
connected to the standby
CPU Unit.
Single CPU Systems
Supported from CX-Programmer
version 4.0. CX-Programmer Version
3.@ or lower cannot be used.
Select "CS1D-S" as the device type.
Online connection will not be possi-
ble if "CS1D-H" is selected.
Duplex operation must be set in the
PLC Setup.
---
Appendix E
CS1-H (See note.)
Supported from CX-
Programmer ver-
sion 2.1.
Select "CS1H-H" as
the device type.
---