Displaying And Maintaining Cluster Configurations; Configuring Cluster Parameters - 3Com 5500-SI Configuration Manual

Configuring Cluster
Parameters
Displaying and
Maintaining Cluster
Configurations
Table 668 Configure cluster parameters
Operation Command
Enter system view system-view
Enter cluster view cluster
Add a candidate add-member [ member-number
device to a cluster ] mac-address H-H-H [
password password ]
Remove a member delete-member
from the cluster member-number
Reset a specified reboot member { member-num
member device | mac-address H-H-H } [
eraseflash ]
Exit cluster view quit
Exit system view quit
Switch between the cluster switch-to {
management device member-number | mac-address
and member devices H-H-H | administrator }
You can view the configuration information of a cluster with the display commands,
which can be executed in any view.
Table 669 Display and maintain cluster configurations
Operation Command
Display global NDP display ndp
configuration
information including
NDP packet interval
and hold time
Display neighbor display ndp interface port-list
information collected
through port NDP
Display global NTDP display ntdp
information
Display device display ntdp device-list [
information collected verbose ]
through NTDP
Display state and basic display cluster
configuration
information of a
cluster
Display candidate display cluster candidates [
devices of a cluster mac-address H-H-H | verbose ]
Display cluster display cluster members [
member information member-num | verbose ]
Clear the NDP reset ndp statistics [ interface
statistics on a port port-list ]

Configuring Cluster Parameters 609

Remark
—
—
This is to add a new member.
Arguments member-number, H-H-H
and password are the ID, MAC address
and password of the member device
respectively.
Optional
This is to remove a member from the
cluster.
Optional
—
—
Optional
This is to switch to a member device
according to the MAC address.
Remark
Optional
The display command can be
executed in any view.
Optional
The display command can be
executed in any view.
Optional
The display command can be
executed in any view.
Optional
The display command can be
executed in any view.
Optional
The display command can be
executed in any view.
Optional
The display command can be
executed in any view.
Optional
The display command can be
executed in any view.
Optional