Displaying And Maintaining Basic Port Configuration - 3Com 5500-EI PWR Install Manual

To do ...
Set the port state change
delay
The delay configured in this way does not take effect for ports in DLDP down state. For information
about the DLDP down state, refer to DLDP.

Displaying and Maintaining Basic Port Configuration

To do...
Display port configuration
information
Display the enable/disable
status of port loopback
detection
Display brief information about
port configuration
Display port information about
a specified unit
Display the storm control
configurations.
Display the statistics on the
packets dropped on a port or all
ports
Display the information about
the port with the link-delay
command configured
Clear the statistics on packets
dropped on a port or all ports
Clear port statistics
Use the command ...
link-delay delay-time
Use the command...
display interface [ interface-type |
interface-type interface-number ]
display loopback-detection
display brief interface [ interface-type
[ interface-number ] ] [ | { begin | include |
exclude } regular-expression ]
display unit unit-id interface
display storm-constrain [ interface
interface-type interface-number ] [ | { begin
| exclude | include } regular-expression ]
display packet-drop { interface
[ interface-type interface-number ] |
summary }
display link-delay
reset packet-drop interface
[ interface-type interface-number ]
reset counters interface [ interface-type |
interface-type interface-number ]
1-11
Remarks
Required
Defaults to 0, which indicates that no
delay is introduced.
Available in any
view
Available in user
view
Available in user
view
After 802.1x is
enabled on a port,
clearing the
statistics on the port
will not work.
Remarks