Displaying And Maintaining Basic Configurations - 3Com 4210G Series Configuration Manual

When you configure the password for switching user privilege level with the super password
command, the user privilege level is 3 if no user privilege level is specified.
The password for switching user privilege level can be displayed in both cipher text and simple
text. You are recommended to adopt the former as the latter is easily cracked.
Modifying command level
All the commands in a view are defaulted to different levels, as shown in
can modify the command level based on users' needs to make users of a lower level use commands
with a higher level or improve device security.
Follow these steps to modify the command level:
To do...
Enter system view
Configure the command level
in a specified view
You are recommended to use the default command level or modify the command level under the
guidance of professional staff; otherwise, the change of command level may bring inconvenience to
your maintenance and operation, or even potential security problem.

Displaying and Maintaining Basic Configurations

Display information on system version
Display information on the system clock
Display defined command aliases and the
corresponding commands
Display information on terminal users
Display the valid configuration under
current view
Display clipboard information
Display and save statistics of each
module's running status
Use the command...
system-view
command-privilege level
level view view command
To do... Use the command...
display version
display clock
display command-alias
display users [ all ]
display this [ by-linenum ]
display clipboard
display diagnostic-information
9-14
Table 9-3. The administrator
Remarks
—
Required
Refer to Table 9-3 for the
default settings.
Remarks
Available in
any view