Displaying And Maintaining Basic Port Configuration - 3Com 4500 Configuration Manual

The port state change delay takes effect when the port goes down but not when the port goes up.
Follow these steps to set the port state change delay:
To do ...
Enter system view
Enter Ethernet interface
view
Set the port state change
delay
The delay configured in this way does not take effect for ports in DLDP down state. For information
about the DLDP down state, refer to DLDP.

Displaying and Maintaining Basic Port Configuration

To do...
Display port configuration
information
Display the enable/disable
status of port loopback
detection
Display brief information about
port configuration
Display port information about
a specified unit
Display the Combo ports and
the corresponding
optical/electrical ports
Display the information about
the port with the link-delay
command configured
Use the command ...
system-view
interface interface-type
interface-number
link-delay delay-time
Use the command...
display interface [ interface-type |
interface-type interface-number ]
display loopback-detection
display brief interface [ interface-type
[ interface-number ] ] [ | { begin | include |
exclude } regular-expression ]
display unit unit-id interface
display port combo
display link-delay
1-8
Remarks
—
—
Required
Defaults to 0, which indicates that no
delay is introduced.
Available in any
view
Remarks