Displaying And Maintaining Basic Port Configuration; Ethernet Port Configuration Example - 3Com E4500-24 Cli Configuration Manual

To do ...
Set the port state change
delay
The delay configured in this way does not take effect for ports in DLDP down state. For information
about the DLDP down state, refer to DLDP.

Displaying and Maintaining Basic Port Configuration

To do...
Display port configuration
information
Display the enable/disable
status of port loopback
detection
Display brief information about
port configuration
Display port information about
a specified unit
Display the Combo ports and
the corresponding
optical/electrical ports
Display the information about
the port with the link-delay
command configured
Clear port statistics

Ethernet Port Configuration Example

Network requirements
Switch A and Switch B are connected to each other through two trunk port (Ethernet 1/0/1).
Configure the default VLAN ID of both Ethernet 1/0/1 to 100.
Allow the packets of VLAN 2, VLAN 6 through VLAN 50 and VLAN 100 to pass both Ethernet 1/0/1.
Use the command ...
link-delay delay-time
Use the command...
display interface [ interface-type |
interface-type interface-number ]
display loopback-detection
display brief interface [ interface-type
[ interface-number ] ] [ | { begin | include |
exclude } regular-expression ]
display unit unit-id interface
display port combo
display link-delay
reset counters interface [ interface-type |
interface-type interface-number ]
1-11
Remarks
Required
Defaults to 0, which indicates that no
delay is introduced.
Available in any
view
Available in user
view
After 802.1x is
enabled on a port,
clearing the
statistics on the port
will not work.
Remarks