Displaying And Maintaining Gvrp - 3Com 4200G 12-Port Configuration Manual

Displaying and
Maintaining GVRP
Network diagram
Figure 24 Network diagram for GVRP configuration
Configuration procedure
1 Configure switch A:
a Enable GVRP globally.
<S4200G> system-view
[4200G] gvrp
b Set the port GigabitEthernet1/0/1 to a trunk port, and allow all VLAN packets to
pass through the port.
[4200G] interface GigabitEthernet1/0/1
[4200G-GigabitEthernet1/0/1] port link-type trunk
[4200G-GigabitEthernet1/0/1] port trunk permit vlan all
c Enable GVRP on the trunk port.
[4200G-GigabitEthernet1/0/1] gvrp
2 Configure switch B:
a Enable GVRP globally.
<S4200G> system-view
[4200G] gvrp
b Set the port GigabitEthernet1/0/2 to a trunk port, and allow all VLAN packets to
pass through the port.
[4200G] interface GigabitEthernet1/0/2
[4200G-GigabitEthernet1/0/2] port link-type trunk
[4200G-GigabitEthernet1/0/2] port trunk permit vlan all
c Enable GVRP on the trunk port.
[4200G-GigabitEthernet1/0/2] gvrp
After the above configuration, you can use the display commands in any view to
display the configuration information and operating status of GVRP, and thus verify
your configuration. You can use the reset garp statistics command in user view to
clear GARP statistics.
Table 44 Display and maintain GVRP
Operation
Display GARP statistics
Display the settings of the GARP
timers
Display GVRP statistics
Display the global GVRP status
Clear GARP statistics
E 1 / 0 / 1
S w S w S w S w i t c h A i t c h A i t c h A i t c h A
Command
display garp statistics [ interface interface-list ]
display garp timer [ interface interface-list ]
display gvrp statistics [ interface interface-list ]
display gvrp status
reset garp statistics [ interface interface-list ]

Displaying and Maintaining GVRP

E 1 / 0 / 2
S w S w S w S w i t c h B i t c h B i t c h B i t c h B
65