Configuration Example For Tty Terminal Access - 3Com MSR 50 Series Configuration Manual

Configuration Example
for TTY Terminal Access
exchange with the router-side programs. To configure your FEP, refer to the related
sections in "FEP Installation and Configuration" on page
Network requirements
The deposit services run on the Unix server, whose IP address is 1.1.254.77/16. The
listening port of the ttyd program on the Unix server is 9010.
The router is connected to four terminals through its four asynchronous interfaces.
The source IP address to be bound is 2.2.2.1/32.
Network diagram
Figure 224 Network diagram for TTY terminal access configuration
Configuration procedure
Perform the following configuration in one-to-one mode:
Configure the initiator (router).
■
# Enable terminal access.
<Sysname> system-view
[Sysname] rta server enable
# Create a template and enter template view.
■
[Sysname] rta template temp1
# Configure a VTY application.
[Sysname-rta-template-temp1] vty 0 tty remote 1.1.254.77 9010
[Sysname-rta-template-temp1] quit
# Configure the Ethernet interface.
[Sysname] interface ethernet 0/0
[Sysname-Ethernet0/0] ip address 1.1.247.88 255.255.0.0
[Sysname-Ethernet0/0] quit
# Create a Loopback interface and configure source IP address binding.
TTY Terminal Access Configuration
771.
753