Tty Terminal Access Configuration - 3Com MSR 50 Series Configuration Manual

3com msr 30-16: software guide

Hide thumbs Also See for MSR 50 Series:

Safety information manual (12 pages)

Table of Contents

TTY Terminal Access

Configuration

used for implementing the extended functions of terminal access. Display and

maintenance commands are used for displaying and debugging terminal access.

In terms of view, the configuration commands can be classified as the commands

available in user view, commands available in system view, commands available in

template view, and commands available in interface view. Most important

configurations of the terminal access system are performed in templates. You can

save a series of router parameter configurations in a template. When applying a

template to an interface, (an asynchronous interface, for example), the system

creates a TTY according to the contents of the template and the specified terminal

number, and sets up VTYs on the basis of the configuration information in the

template. If you modify a template that was applied to an interface, you can use

the update changed-config command to update the configuration of the

terminal using the template. For convenience, you can configure multiple

templates at the same time and apply the templates on different interfaces. Note

that only one template can be applied on one interface.

Complete the following tasks to configure terminal access.

Configuration task

Configure TTY terminal access

Configure Telnet terminal access

Configure RTC terminal access

Configuring the TTY Initiator

Follow these steps to perform basic TTY initiator configuration:

Enter system view

Enable terminal access on

Create a terminal template

and enter terminal

template view

Configure a TTY VTY