3Com MSR 50 Series Configuration Manual page 496

496 C 24: VLAN C
HAPTER ONFIGURATION
<DeviceA> display interface ethernet 1/0
Ethernet1/0 current state: UP
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0000-5600-0000
Description: Ethernet1/0 Interface
Loopback is not set
Unknown-speed mode, unknown-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 1500
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 100
Mdi type: auto
Link delay is 0(sec)
Port link-type: trunk
VLAN passing
VLAN permitted: 1(default vlan), 2, 6-50, 100
Trunk port encapsulation: IEEE 802.1q
Port priority: 0
Last 300 seconds input:
Last 300 seconds output:
Input (total):
0 broadcasts, 0 multicasts
Input (normal):
0 broadcasts, 0 multicasts
Input: 0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, 0 overruns, 0 aborts
0 ignored, 0 parity errors
Output (total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output (normal): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output: 0 output errors, 0 underruns, 0 buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, 0 no carrier
The output above shows that:
The port is a trunk port.
■
The default VLAN is VLAN 100.
■
The port permits packets of VLAN 2, VLAN 6 through VLAN 50, and VLAN 100.
■
So the configuration is successful.
2, 6-50, 100
0 packets/sec 0 bytes/sec
0 packets/sec 0 bytes/sec
0 packets, 0 bytes
0 packets, 0 bytes