Calibrating The Stepper Motor (Sm-Cali) - Dürkopp Adler 550-D800 Operating Instructions Manual

Programming
Registering a needle change
To register a needle change:
1. Open the needle database ( p. 143).
2. Press the Exchange button.
 The display switches to:
Fig. 137: Registering a needle change
3. Change the needle ( Operating Instructions).
4. Modify the data if necessary.
5. Confirm with OK.

5.6.17 Calibrating the stepper motor (SM-Cali)

If the function Calibration control is active, the user will be
prompted at regular intervals to check the settings of the stepper motor
and re-calibrate them if necessary.
The stepper motor may only be calibrated by technicians with security
level 2. These work steps are documented in the stepper motor calibration
database.
Information
If the function Calibration control is deactivated on the Setup
display, the SM-Cali button will be displayed semi-transparent.
To open the stepper motor calibration database:
1. Log in with security level 2 ( p. 75).
2. Open the Checks display ( p. 125).
3. Press the SM-Cali button.
 The display switches to:
144 Operating Instructions 550-D800 - 01.0 - 05/2023