Table of Contents
Advertisement
58
5.4.4
Setting the Thread clamp parameter
(Thread Clamp)
If a thread clamp is present, this function can be activated or
deactivated here. The thread clamp is closed for the 1
the seam to ensure that the needle thread lies on the underside
of the sewing material.
Menu item
(Thread Clamp)
Thread clamp
5.4.5
Setting the Initial alignment stitch parameter
(PointPos.°)
The distance of the needle from the material can be adjusted to
allow precise positioning of the sewing material when starting
sewing. The value entered here corresponds to the degree number
on the handwheel.
Menu item
(PointPos.°)
Initial alignment stitch
function
5.4.6
Setting the Start bartack parameter
(Start Tack)
There are various options for setting the start bartack. All subitems
in the Start Tack menu are listed in the following table.
Operating Instructions 667 PREMIUM - 02.0 - 01/2018
Setting option
ON = on
OFF = off
Setting option
000 – 359 [°]
Programming
st
stitch of
Advertisement
Table of Contents
