Adjusting The Vivo 45 Ls Patient Settings - Breas Vivo 45 LS User Manual

Inspection at Ventilator Startup
This procedure checks the ventilator's alarm handling and power source handling. If any
check fails, take the ventilator out of use and contact your service provider.
1 Connect a patient circuit to the ventilator
2 Connect the power supply to the ventilator. If the power is supply is connected and
the ventilator is turned off, press the Start/Stop button.
⇒The ventilator now turns on and enters stand by mode. If it is the first time the
ventilator is turned on, you also have to select language.
3 If needed, perform a pre-use test.
4 Press and hold the Start/Stop button until the progress bar is filled to start the
treatment.
⇒At the start of the treatment the ventilator performs an alarm test. Check that:
• The alarm LEDs flash
• The ventilator beeps
5 Disconnect the power supply for more than 5 seconds.
⇒The ventilator now switches to the internal battery (or click-in battery, if connected).
Check that Lost mains power alarm is given.
6 Reconnect the power supply.
Check that the device switches to the mains supply, indicated by an information
message and a beep.
7 Ensure that the treatment settings and alarm settings are set as prescribed before
taking the ventilator to use.
4.6

Adjusting the Vivo 45 LS Patient Settings

WARNING!
The configuration of the Vivo 45 LS therapy settings must always be prescribed by a
licensed physician and carried out by an authorised health care professional.
For detailed information about the treatment parameters of the Vivo 45 LS, see 5.5 Func-
tions and Parameters in the Vivo 45 LS, page 76.
Follow the instructions below when setting up the Vivo 45 LS:
•
•
•
Doc. 007301 K-1
Adjust the settings to find the best possible breathing comfort for the patient.
If you have changed the ventilation mode, press Select Next and review the settings
before pressing Confirm.
Always document the patient settings.
Preparing the Vivo 45 LS for Use 51
User manual