Electrical Safety - Breas Vivo 45 LS User Manual

2.2

Electrical Safety

WARNING!
Risk of Electric Shock
High voltage contact may cause cardiac arrhythmia.
•
•
•
•
•
•
WARNING!
Risk of Faulty Treatment
Electromagnetic Interference may cause electrical equipment to malfunction.
•
•
•
Doc. 007301 K-1
Do not operate the Vivo 45 LS if it has a damaged power cord, power supply or
casing.
To avoid electrical shock, only clean the Vivo 45 LS according to instructions in
this manual. Do not soak or immerse the Vivo 45 LS into any fluids.
Use the approved power supply units only.
Use of unapproved power supply units may compromise the electrical isolation
and lead to risk of electric shock.
Do not use more than one multiple portable socket-outlet or extension cord.
If a multiple portable socket-outlet is used, it must not be placed on the floor.
The operator must not touch accessible contacts of connectors and the patient
simultaneously.
Nurse Call must only be connected to a safety extra low voltage system with an
isolation from mains voltage which complies with the requirements of IEC
60601-1.
The aspects of electromagnetic compatibility must be considered.
• The Vivo 45 LS should not be used adjacent to or stacked with other
equipment; if adjacent or stacked use is necessary, the Vivo 45 LS
should be observed to verify normal operation in that configuration.
• Mobile or transportable radio transmitters may interfere with the
Vivo 45 LS.
• Further guidance for safe installation of the ventilator can be found in
the chapter about emission and immunity declaration.
If a portable AC power supply is used, make sure that the voltage variations are
within the operating limits of the Vivo 45 LS.
Portable RF communications equipment (including peripherals such as antenna
cables and external antennas) should be used no closer than 30 cm (12 inches) to
any part of the Vivo 45 LS, including cables specified. Otherwise, degradation of
the performance of this equipment could result.
Safety Information
User manual
23