Pre-use Test Sequence
When performing a pre-use test, the instructions on the display will guide you through
this sequence:
Step
1
2
3
4
5
6
7
Doc. 007301 K-1
Action
Start of pre-use test.
Connect the patient circuit.
Make sure that nothing is blocking the patient end of the circuit.
Wait while the Vivo 45 LS is checking the patient circuit resistance.
If the resistance is not within the limits, the test will end without per-
forming the following steps. The result will be displayed for review.
Block the end of the patient circuit with an air tight object.
Wait while the Vivo 45 LS is checking the patient circuit compliance
and leakage.
Test finished. Review the test result.
Preparing the Vivo 45 LS for Use
53
User manual