Breas iSleep20+, iSleep20i, iSleep22, iSleep25 Quick Reference Guide

Product Description

Symbols Used in the Menu

ICON	EXPLANATION
	The iSleep is operating
	Wake up alarm
	HA 20 humidifier active
	Ramp active
	Panel locked (home mode)
	Panel locked (home mode) by the Breas iSleep PC software

Quick Usage Guide

Thank you for choosing an iSleep product. The iSleep is a CPAP system that provides continuous positive airway pressure for homecare. This Quick Reference Guide allows you to easily start up your treatment. Please note that the iSleep 20+ is used as an example. The display may appear different on iSleep 20i/22/25.

This is not a complete guide for the iSleep. See your manual for complete instructions.

Switching On and Off

1. Make sure the power supply is connected.
   
2. Turn on/off the iSleep by pressing the Start/Stop button for 2 seconds.
   

Using the Menu

Use the 4 buttons under the display to navigate in the menu. You can alter device settings and settings for wake up alarm, humidifier and ramp as well as view the treatment settings. Depending on the location in the menu, the buttons have different functions. The following icons are used:

ICON	EXPLANATION
	Increase the selected value or turn a function On.
	Decrease the selected value or turn a function Off.
	Move up one step in the menu system.
	Enter the menu or select the value below.

Using the Memory Card

The iSleep can only copy and transfer data to the memory card in standby mode (not operating).

1. Insert the memory card in the memory card slot on the side of the iSleep.
   
2. At the main menu, choose "Others" and navigate to the "Memory Card" page.
   
3. Select the desired operation and wait while the iSleep loads or saves data to the memory card.
   
4. Remove the memory card from the memory card slot on the side of the iSleep.
   

Snooze Function

1. Shortly press the Start/Stop button.
   
2. The snooze function activates and the iSleep delivers a low flow.
   

In order to start the treatment again, start to breathe in the mask or press the Start/Stop button shortly.

Alarm Clock

Navigate to the wakeup alarm screen to turn the wakeup alarm on and off.
The wake up function will initiate an alarm at the wakeup time when activated.
Press the Start/Stop button to turn off the alarm signal when the alarm is going off.

Cleaning and Replacing the Patient Air Filter

The patient air filter is located on the side of the iSleep.

There are two types of filters:

Washable Filter (grey colour, mandatory)
Replace the washable filter at least once a year. Wash the filter at least once a week.

Disposable Filter (white colour, optional)
Replace the filter at least every 4th week, or more often when used in high pollution or pollen-rich environments.

Shortcuts

To activate/inactivate the ramp function while the iSleep is running: Press and hold the Ramp soft key until the ramp symbol appears/ disappears.

To activate/inactivate the humidifier while the iSleep is running: Press and hold the Humidity soft key until the humidity symbol appears/disappears.

Checking the iSleep Before Use

1. Connect a cleaned or new patient circuit to the iSleep.
2. Connect the iSleep to the mains supply.
3. Switch on the iSleep by pressing the Start/Stop button on the front panel. Ensure that the iSleep is running.
4. Put on the mask and adjust its fit.
5. Ensure that the settings are adjusted as prescribed.

The iSleep is ready for use.

Breas Medical AB, Företagsvägen 1,
SE-435 33 Mölnlycke, Sweden,
Phone: +46 31 86 88 00, Fax: +46 31 86 88 10,
breas@breas.com
Find your local distributor at www.breas.com