Keysight Technologies C Series User Manual page 745

Fieldfox analyzers

(Not IQA) Moves the active marker to the next data point to the right that meets the

'Peak' criteria. When no data points to the right meet the 'Peak' criteria, the marker does not

The following applies to DTF Measurements ONLY:

Track Peaks ON OFF

sweep. While in this Mode, the markers can NOT be turned OFF or moved.

Find 3 Peaks

The following applies to IQA Measurements ONLY:

Moves the active marker to the minimum frequency (IQA displays time) currently

displayed on the screen.

Mkr Properties

Peak Criteria

Delta Ref Fixed

(IQA Spectrum Only) Moves the active marker to the next data point to the left that

meets the 'Peak' criteria. When no data points to the left meet the 'Peak' criteria, the marker

does not move.

(IQA Spectrum Only) Moves the active marker to the next data point to the right that

meets the 'Peak' criteria. When no data points to the right meet the 'Peak' criteria, the marker

does not move.

Using Mkr5/Mkr6 to find mins/maxs between Mkr1 and Mkr2 / Mkr3 and Mkr4 (CAT and NA

Use this feature to search minimum and maximum values within sub-spans defined by Mkr1 and

Mkr2, and Mkr3 and Mkr4. This facilitates measuring minimum and maximum values on your uplink

and downlink channels, or only in the passband of a DUT. Use in conjunction with marker table and

limit lines to verify your DUT's signals and to adjust or tune as needed. See also,

Lines" on page

When markers are set to Normal, Mkr5 and Mkr6 can be used to find the minimum and or

maximum values between Mkr1 and Mkr2 (using Mkr5) and Mkr3 and Mkr4 (using Mkr6). Refer to

Figure 30-6 on page

Keysight N9915-90020 User's Guide

Data Analysis FeaturesDELETE_IF

All about Markers

When Track Peaks is ON, markers will find the new peak with every

Three markers are created and find the highest peaks (faults) on the trace.

then refer to

"How to set Peak Criteria" on page

Enables or disables the delta reference fixed marker.

"All about Limit

Chapters