Keysight Technologies C Series User Manual page 441

5G Rapid Prototype Phased Array Antenna – Option 360
How to Set Up Phased Array Antenna Settings
13. Optional: Press Freq/Dist
14. Optional: choose change sweep, dwell time, and max hold settings:
15. Optional: choose devices and save files:
Keysight N9915-90020 User's Guide
— Polar Orientation
direction.
— Image Enable OFF ON
direction. Only active if you have recalled a PNG image to display on
the FieldFox as a map. (Default = OFF)
— Recall Image
Use to recall PNG map to overlay antenna direction.
— Compass Image OFF ON
for antenna. (Default = ON)
— Compass North
value in degrees.
Repeat process as needed for additional settings.
— Press Antenna Settings
menu, where you can define your phased array antenna settings,
Ball Antenna: LAN address, Settings: Resolution BW, Video BW,
Beam Width, Array Antenna: Center frequency, Azimuth Ref,
Elevation Ref, and Polar Display: Ref. For details, refer to step
above.
— Then Start Azimuth
— Then Stop Azimuth
— Then Ref Elevation
Press Sweep
Then choose:
— Dwell Time
to set the delay between the antenna positioning from
1 ms to 10 seconds (default: 10 ms). For pulsed RF measurements it
is recommended that you increase the Dwell Time to ~100 ms.
— Max Hold For pulsed RF measurements, it is recommended that Max
Hold is set to OFF when using the Heat Map display.
(Default = OFF)
— Single
— Continuous
to enable or disable the continuous sweep (default:
ON).
Learn more, refer to
(Option 233–Mixed Analyzers)FUTURE."
— Restart
Press Save/Recall
Aligns the antenna polar display to a selected
(Optional to overlay antenna bore-sight
To display a compass indicating true north
Use this softkey to align the compass' true north
opens the table antenna settings softkey
+/-45 degrees. (Default = 45 degrees)
+/-45 degrees. (Default = 45 degrees)
+/-45 degrees. (Default = 0 degrees)
Chapter 9, "SA (Spectrum Analyzer) Mode
6
441