Advertisement
Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option
233), and GPS Receiver (Option 307))
How to Use Data Logging (Option 352)
During recording, choose from the following:
—
—
To change Data Logging Configuration settings:
— Press Trace 6
— Then
— Then
— Then
Learn more, refer to the
How to Play a Data Log
— Press Trace 6
— If the session is already open, skip the following step. Otherwise:
Keysight N9915-90020 User's Guide
is displayed in the left of screen graticules.
Pause Resume
Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue recording.
Stop
Immediately stops recording. Then choose from the following:
Record Save/Recall
— Then
change your file settings. Learn more, refer to
Logging Configuration settings:" on page
Save Log File
——Press
save device is Internal).
— Then
Record Settings
measurement interval settings. Learn more, refer to
Logging Configuration settings:" on page
Data Logging
then choose:
Record Settings
Meas Interval
— Optional: Then
——Then
Interval Type
——Then, if applicable
Or
——Then, if applicable
miters.
Record Save/Recall
Device
(Internal (default), SD Card, or USB)
— Then
— Then
File Type
(CSV (default), DREC (Option 360 Only), or KML)
Chapter 33, "File
To save a log file, recall a log file, or
to save the current Table data (i.e., default
(Outdoor Mapping only) To change your
(Outdoor Mapping only)
> ON
> choose Time or Distance.
Time Interval
Distance Interval
Management".
"To change Data
517.
"To change Data
517.
enter time interval in seconds.
enter distance interval in
517
Advertisement
Chapters
