Keysight Technologies C Series User Manual page 457

5G Rapid Prototype Phased Array Antenna – Option 360
How to Use Data Logging/Playback (Option 360)
How to Record a Data Log
Data Log-Play files are saved to:
—
—
— Press Trace 6
— Then
— Then
During recording, choose from the following:
—
—
To change Data Logging Configuration settings:
— Press Trace 6
— Then
— Then
Keysight N9915-90020 User's Guide
If File Folder is set to Default then Data Log-Play files are save-recalled
to:
"[CurrentDevice]\RecordPlayback\PAA"
If File Folders are set to System, then Data Log-Play files are
save-recalled to:
"CurrentDevice\<UserSelectedFolder>\
Data Logging
Record
is displayed in the left of screen graticules.
Pause Resume Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue recording.
Stop Immediately stops recording. Then choose from the following:
Record Save/Recall
— Then
your file settings. Learn more, refer to
Configuration settings:" on page
Save Log File
——Press
save device is Internal).
Record Settings
— Then
measurement interval settings. Learn more, refer to
Logging Configuration settings:" on page
Data Logging
then choose:
Record Settings
Meas Interval
— Optional: Then
Interval Type
——Then
——Then, if applicable
Or
——Then, if applicable
miters.
To save a log file, recall log file, or change
"To change Data Logging
456.
to save the current Table data (i.e., default
(Outdoor Logging) To change your
(Outdoor Mapping Only)
> ON
> choose Time or Distance.
Time Interval
Distance Interval
"To change Data
456.
enter time interval in seconds.
enter distance interval in
457