Keysight Technologies C Series User Manual page 179

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)FUTURE
SA Mode Settings
— If you have previously stored an audio file:
— Press
— Press
— Then
Keysight N9915-90020 User's Guide
Stop
Press to stop the current capture of audio data and depending on the
timing of pressing Stop, possibly prevent the audio data from being stored.
Press Playback then
— Play – to play the last current audio file (*.wave) loaded into memory.
Stop
— – to disable playback of the current audio file.
— Volume Mute – to enable disable volume and to adjust the volume
from 0 to 100 (default = Mute /Volume == 10).
— Load Audio File
Cap Auto–Load
—
captured audio (.wav) file (default = OFF).
Capture Settings
— Capture Count – sets the number of audio captures for a
measurement (Default = 1; Settable: 1 to 100K).
— Capture Time – sets the capture time (Default = 100 ms).
Minimum/Maximum capture times vary with other settings.
Stereo Channel
—
softkey sets the type of audio to be captured and stored: (Choose
Mono
single channel:
Or choose two channel:
Then Choose:
Mono (L+R)
Stereo (L&R)
Left (L)
Right (R)
Difference (L–R)
Back to return to previous menu.
File Settings then
Filename
— – Opens the filename labeler to specify a filename.
– to load a previously stored audio (.wave) file.
– enable/disables automatically loading of a
then
– When Demod Type = FM Stereo / RDS, this
(L+R), Left (L), Right
Stereo (L&R). Default = Mono (L+R).
Sets the audio recording to Mono (single channel) and
combining left and right speaker sounds. This is the
default.
Sets the audio recorded to be stereo (two channels).
Sets the audio to be recorded to be the left speaker only.
Sets the audio to be recorded to be the right speaker
only.
Sets the audio to be recorded to be the value of the left
side minus the right side of the audio data (single
channel).
(R), and Difference (L–R).
179