Keysight Technologies C Series User Manual page 385

Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option 371, 5G TF
Option 377, 5G NR / 5G NR EVM Conducted Option 378
How to Set Up Over–the–Air (OTA) Mode Settings
2. Selecting and OTA mode: Press
3. Optimizing the FieldFox to scan for signals:
Keysight N9915-90020 User's Guide
5G NR or 5G NR EVM Conducted
— Set the System >
Source [GPS] >Back
— Set the GNSS (GPS+)
See also "GNSS (GPS+) and GPS" on page
— Set the Scale/Amptd to:
— RF Atten
— Preamp
— Set the Freq/Dist > then optionally:
All Measurement Setups:
— Press CC CCO
— Press Enabled OFF ON
component carriers. If only one CC is enabled, the OFF key
press is ignored (default = ON).
— Press Center
carrier center frequency.
For LTE FDD and LTE TDD (instrument dependent)
— Optional (LTE FDD and LTE TDD only):
For 5G NR (instrument dependent)
— Optional (5G NR only):
Measure > LTE FDD
System Configuration
GNSS Receiver
>
> 0 dB
> ON
Enable/disable selected
to select the currently displayed component
——Freq Mode > Chan
——Then Channel Table
your CC, Band, Channel, and then use
List, to open a softkey menu to save your
n.
——Offset frequency offset of the measurement
frequency from the center frequency
——Freq Mode > Chan
——Then Channel Table
your CC, Band, Raster Mode Chan
Channel Raster
then use
Then Channel ARFCN, Center, or
Else
or LTE TDD or 5G TF
Frequency Ref Freq Ref
> >
Internal > Esc
>
795.
– Opens a menu to choose
Favorites
Setup
– Opens a menu to choose
Sync, and
to open a softkey menu:
Offset
or
385