Advertisement
5G Rapid Prototype Phased Array Antenna – Option 360
How to Set Up Phased Array Antenna Settings
Step 3. Define the measurement
1. Press Preset then
2. Selecting Phased Array Antenna mode: Press
3. Optimizing the FieldFox to scan for signals:
Keysight N9915-90020 User's Guide
1. In the Setting screen, use the
numeric keypad to highlight Obtain IP.
2. Press
Obtain IP Static
3. Press Clear, then set the Static IP Address to: 192.168.1.2
and
Done
4. Press
5. Press Clear, then set the Static Subnet Mask to:
255.255.255.0
and
Done
6. Press
7. Press Clear, then set the Static Gateway to: 192.168.1.254
and
Done
8. Press
9. Using the
select Apply Settings.
10. Press Edit, then select Now.
11. Press
Done Edit
Mode Preset (Factory)
Antenna. Depending on the number of options loaded on your FieldFox, it
may be necessary to press More.
a. Run the Antenna Wizard: Measure >
prompts.
b. Set the
Measure
ANT).
See also
"How to Set Up Phased Array Antenna Settings" on
page
433.
c. Set the Meas Setup >
— Ball Antenna: LAN address
— Settings: Res BW, Video BW, and Beam Width
arrows, the rotary knob, or numeric keypad to
>
Done
Antenna Wizard
type (i.e., Bore-Sight, Heat Map, Polar ANT, or Park
Antenna Settings
arrows, the rotary knob, or
Mode
>
Phased Array
and follow the
table:
447
Advertisement
Chapters
